Nissan Sentra Service Manual: Glove box lamp
Removal and installation
Warning:
Do not touch bulb while it is lit or right after being turned off. Burning may result.
Caution:
Do not touch glass surface of the bulb with bare hands or allow oil or grease to get on it to prevent damage to bulb.
Removal
- Remove the glove box assembly. Refer to ip-22, "removal and installation".
- Rotate the glove box lamp socket assembly counterclockwise and remove.
- Remove the glove box lamp housing.
Installation
- Install the glove box lamp housing.
- Insert bulb socket into glove box lamp housing and rotate clockwise to lock in position.
- Install glove box assembly. Refer to ip-22, "removal and installation".
Bulb replacement
The glove box lamp bulb is serviced as part of the glove box lamp socket. Refer to inl-54, "removal and installation".
Vanity mirror lamp
Removal and installation
Caution:
Do not attempt to separate the vanity mirror lamp from the sun visor or
damage to the components
may occur.
Note:
The vanity mirror lamp is replaced as part o ...
Interior room lamp
Removal and installation
Removal
Insert a suitable tool into the gap between the headlining and the
interior room lamp and release the interior
room lamp.
Disconnect the harness connector ...
Other materials:
Primary speed sensor
Exploded View
Transaxle assembly
O-ring
Primary speed sensor
: Always replace after every
disassembly.
: N m (kg-m, in-lb)
: Genuine NISSAN CVT Fluid NS-3
Removal and Installation
REMOVAL
Disconnect the primary speed sensor connector.
Remove the primary speed sensor.
...
Wiring diagram
Interior room lamp control system
Wiring diagram
Illumination
Wiring diagram
...
Wheel sensor
Front wheel sensor
FRONT WHEEL SENSOR : Exploded View
Front wheel sensor
Front wheel sensor harness connector
Front
FRONT WHEEL SENSOR : Removal and Installation
CAUTION:
Be careful not to damage wheel sensor edge and sensor
rotor teeth.
When removing the front ...
