S Nissan Sentra Manuals Library
Factory-style information for owners and repair work

Nissan Sentra techinfo

Find Nissan Sentra owner information, maintenance instructions, technical references, service procedures and useful repair pages in one clean online library.

Quick access Sentra Docs
B18 Owner's 2020-2025 Sentra owner information B18 Service 2020-2025 Sentra Workshop manual B17 Owner's 2013-2019 Sentra owner documentation B17 Service 2013-2019 Sentra service information

Nissan Sentra B18 (2020-2025) Service Manual: Crash Zone Sensor

Exploded View

Exploded View

1.

Crash zone sensor

2.

Crash zone sensor bracket

A.

Crash zone sensor harness connector

Front

Pawl

Removal and Installation

Removal and Installation

REMOVAL

Warning:

  • Before servicing the SRS, place the ignition switch in the OFF position, disconnect both battery terminals then wait at least three minutes.

  • Do not use air tools or electric tools for servicing the crash zone sensor.

Disconnect the negative and positive battery terminals, then wait at least three minutes. Refer to Battery Disconnect.

Using suitable tool, remove clips (A) and core support cover (1).

Using suitable tool, remove clip (A) from the air duct (1).

: Front

Partially remove air duct (1) in the direction shown to access the crash zone sensor bracket bolts (A).

: Front

Remove and discard bolts from the crash zone sensor bracket.

CAUTION:

Do not reuse the crash zone sensor bracket bolts

Disconnect the harness connector from the crash zone sensor.

Remove and discard the crash zone sensor nut and remove crash zone sensor.

CAUTION:

  • Do not reuse the crash zone sensor nuts.

  • Replace the crash zone sensor if it has been dropped or sustained an impact.

  • Do not strike the crash zone sensor.

  • Replace the crash zone sensor if either the driver air bag or the front passenger air bag has been deployed.

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:

  • Do not reuse the crash zone sensor nut.

  • Do not reuse the crash zone sensor bracket bolts.

  • Do not damage the harness connector during installation.

  • After installation is complete, check that no system malfunction is detected causing the air bag warning lamp to illuminate.

  • If a malfunction is indicated by the air bag warning lamp after repair or replacement of the malfunctioning parts, perform the SRS final check. Refer to SRS Final Check.

    Rear Side Air Bag Module. Removal and Installation
    Removal and Installation Removal and Installation Warning: Before servicing the SRS, place the ignition switch in the OFF position, disconnect both battery terminals then wait a...
    Satellite Sensor
    Exploded View Exploded View 1. Front door satellite sensor 2. Rear side air bag satellite sensor Front Pawl         Note: LH side shown; RH side similar. Rem...

    Other materials:

    P159f Active Grille Shutter
    Dtc Description DTC Description DTC DETECTION LOGIC Active grille shutter normally stops within zone which is defined by zone (90°±20°). If the active grille shutter stops within zone stuck error is detected, and if the active grille shutter stops at position beyond zon ...

    B2a1a Rear Camera
    Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition ...

    Operation
    Switch Name and Function Switch Name and Function STEERING SWITCH The steering switch is located on the steering wheel. Transmits the steering switch signal to the combination meter. ...