Nissan Sentra B18 (2020-2025) Service Manual: Rear Side Air Bag Module. Removal and Installation
Removal and Installation
Removal and Installation
Warning:
-
Before servicing the SRS, place the ignition switch in the OFF position, disconnect both battery terminals then wait at least three minutes.
-
Do not use air tools or electric tools for servicing the rear seat bolster.
The rear side air bag module is part of the rear seat bolster. For removal and installation of the rear seat bolster, refer to Removal and Installation.
CAUTION:
-
Always work from the side or back of the rear seat bolster, do not work in front of rear seat bolster.
-
Do not insert any objects into the rear side air bag module.
-
Do not attempt to disassemble the rear side air bag module.
-
Do not expose the rear side air bag module to temperatures exceeding 93°C (200°F).
-
Do not expose the rear side air bag module to any oil, grease, detergent or water.
If the Nissan Sentra vehicle has been involved in a collision and the rear side air bag module has been deployed, the rear seat bolster must be replaced.
Other materials:
Ecu Diagnosis Information
A/c Auto Amp.
Values on the Diagnosis Tool
Values on the
Diagnosis Tool
Note:
The following table includes information (items)
inapplicable to this Nissan Sentra vehicle: For information (items) applicable to
this vehicle, refer to CONSULT display items.
...
Symptom Diagnosis
The Fuel Gauge Indicator Does Not Operate
Description
Description
Fuel gauge will not indicate from a certain
position.
Diagnosis Procedure
Diagnosis Procedure
PERFORM COMBINATION METER
SELF-DIAGNOSIS MODE
Perform the self-diagnosis mode ...
P161f Immobilizer
Dtc Description
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen items
(Trouble diagnosis
content)
DTC detecting condition
...