Nissan Sentra B18 (2020-2025) Service Manual: Confirmation Procedure

Nissan Sentra B18 (2020-2025) Service Manual / Steering / Steering Control System :: Dtc/circuit Diagnosis / C1621-87 Bcm System / Confirmation Procedure

Confirmation Procedure

PRECONDITIONING
1. If “Confirmation Procedure” has been previously conducted, always place the ignition switch OFF and wait at least 10 seconds before conducting the next test.
>>
GO TO 2.
DTC REPRODUCTION PROCEDURE
1. CONSULT
  1. Ignition switch ON.
  2. Select "Self Diagnostic Result" mode of “EPS/DAST 3”.
Is DTC “C1621-87” detected?
YES >>
Proceed to diagnosis procedure. Refer to DTC Diagnosis Procedure.
NO >>
To check malfunction symptom before repair: Refer to Intermittent Incident.
NO >>
Confirmation after repair: Inspection End.

Dtc Description

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis cont ...

Dtc Diagnosis Procedure

DTC Diagnosis Procedure PERFORM SELF DIAGNOSTIC RESULT CONSULT Ignition switch ON. ...

Other materials:

Dtc Diagnosis Procedure
DTC Diagnosis Procedure CHECK OUTSIDE KEY ANTENNA INPUT SIGNAL 1 Ignition switch ON. Check signal between Intelligent Key unit harness connector and ground using oscill ...

Exploded View
Exploded View 1. Brake pedal assembly 2. Clevis pin 3. Brake pedal pad ...

ECO mode switch
The ECO mode in the Nissan Sentra is designed to improve fuel efficiency by optimizing throttle response and transmission shift points during normal driving conditions. To activate ECO mode, press the ECO mode switch. When enabled, the ECO mode indicator light on the meter or vehicle inform ...