Nissan Sentra B18 (2020-2025) Service Manual: Component Function Check
-
CHECK COMBINATION METER INPUT SIGNAL
-
CONSULT-
Select “Data Monitor” mode of “METER/M&A”.
-
Select “BUZZER”.
-
Check that the function operates normally according to the following conditions:
Monitor item
Condition
Status
BUZZER
Under the condition of buzzer input
ON
Except above
OFF
-
Is the inspection result normal?
YES>>Inspection End.
NO>>Refer to Diagnosis Procedure.
-
Description
Description
The buzzer for warning chime system is installed
in the combination meter.
The combination meter sounds the alarm buzzer
based on the signals ...
Diagnosis Procedure
Diagnosis Procedure
CHECK POWER SUPPLY OF COMBINATION
METER
Check power supply of combination meter. Refer to
Diagnosis Procedure (Type A) ...
Other materials:
Headlamp (lo) circuit
Description
The ipdm e/r (intelligent power distribution module engine room) controls the
headlamp low relay based on
inputs from the bcm over the can communication lines. When the headlamp low
relay is energized, power
flows through fuses 43 and 44, located in the ipdm e/r. Power then flows ...
Component Inspection
Component Inspection
CHECK REAR WINDOW DEFOGGER RELAY
Ignition switch OFF.
Disconnect rear window defogger relay.
Check continuity between rear window d ...
Removal and Installation
Removal and Installation
REMOVAL
Remove the
wheel and tire using power tool. Refer to Exploded View.
Remove the
nut and bolt from the lower ball joint. Disconnect the transverse
link from steering knuckle. Refer to Exploded View.
Remove the
nuts and bolts and disconnect ...
