Nissan Sentra B18 (2020-2025) Service Manual: Center Ventilator Grille
Removal and Installation
REMOVAL
Remove instrument finisher B. Refer to Removal and Installation.
Using a
suitable tool, release center ventilator grille pawls. 
|
|
: Pawl |
Disconnect harness connectors from center ventilator grille and remove center ventilator grille.
Remove hazard switch and passenger air bag off indicator from center ventilator grille (if necessary).
INSTALLATION
Installation is in the reverse order of removal.
Rear Floor Duct
Removal and Installation - Rear Floor Connecting Duct
Removal and Installation - Rear Floor Connecting Duct
REMOVAL
Remove
center console side finisher (LH/RH). Refer to Exploded View.
...
Side Ventilator Grille
Removal and Installation
Removal and Installation
SIDE VENTILATOR GRILLE LH
REMOVAL
Remove
instrument lower panel LH. Refer to Removal and Installation.
Using a
suitable tool, re ...
Other materials:
Application Notice
Information
Information
Service information
Design of combination
meter
TYPE A
TYPE B
...
P0078 EVT Control solenoid valve
DTC Logic
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
Possible cause
P0078
EX V/T ACT/CIRC-B1
(Exhaust valve control solenoid circuit
bank 1)
An improper voltage is sent to the ECM
through exhaust v ...
Component Inspection
Component Inspection
CHECK INTELLIGENT KEY BATTERY
Check by connecting a resistance (approximately
300 Ω) so that the current value becomes about 10 mA. Refer to Removal and Installation.
...
