Nissan Sentra B18 (2020-2025) Service Manual: C1f41-62 Cvt
Dtc Description
DTC Description
DTC DETECTION LOGIC
|
DTC |
CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition |
||
|---|---|---|---|---|
|
C1F41 |
62 |
CVT CIRCUIT (Continuously variable transaxle/transmission circuit) |
Diagnosis condition |
|
|
Signal (terminal) |
CAN communication signal |
|||
|
Threshold |
A mismatch between an current gear position signal transmitted from TCM via CAN communication and a gear position calculated by the ADAS control unit 2 continues |
|||
|
Diagnosis delay time |
Approximately 11 minutes or more |
|||
POSSIBLE CAUSE
-
Input speed sensor
-
Output speed sensor
-
TCM
FAIL-SAFE
The following systems are canceled.
-
Nissan Sentra Vehicle-to-vehicle distance control mode
-
Conventional (fixed speed) cruise control mode
-
AEB
-
LDW
-
TSR
-
BSW
-
RCTA
-
RAB
Confirmation Procedure
Confirmation Procedure
-
CHECK DTC PRIORITY
If DTC “C1F41–62” is displayed with Network-DTC or “C1F48–62”, or “C1F48–29” first diagnose the Network-DTC or “C1F48–62”, or “C1F48–29”
Is applicable DTC detected?
YES >>Perform diagnosis of applicable.
-
Network-DTC: DTC Index
-
C1F48–62: DTC Description
-
C1F48–29: DTC Description
GO TO 2 .
-
-
CHECK TCM SELF-DIAGNOSIS RESULTS
Check if any DTC is detected in "Self Diagnostic Result" of "TCM"
Is any DTC detected?
YES >>Perform diagnosis on the detected DTC and repair or replace the malfunctioning parts. DTC Index
NO >>GO TO 3 .
-
PERFORM DTC CONFIRMATION PROCEDURE
-
Start the engine.
-
Turn the AEB system ON.
-
Drive the Nissan Sentra vehicle at 10 km/h (6 MPH) or faster for approximately 15 minutes or more.
Note:
All 15 minutes should be driven by D range. If the driver changes to another shift position in-between, 15 minute will be reset.
CAUTION:
Always drive safely.
-
Stop the Nissan Sentra vehicle.
Is “C1F41–62” detected as the current malfunction?
YES >>DTC Diagnosis Procedure
NO-1 >>To check malfunction symptom before repair: Intermittent Incident
NO-2 >>Confirmation after repair: INSPECTION END
-
Dtc Diagnosis Procedure
DTC Diagnosis Procedure
-
CHECK DTC PRIORITY
If DTC “C1F41–62” is displayed with Network-DTC, “C1F48–62”, or “C1F48–29” first diagnose the Network-DTC, “C1F48–62”, or “C1F48–29”
Is applicable DTC detected?
YES >>Perform diagnosis of applicable.
-
Network-DTC: DTC Index
-
C1F48–62: DTC Description
-
C1F48–29: DTC Description
GO TO 2 .
-
-
CHECK TCM SELF-DIAGNOSIS RESULTS
-
Perform “All DTC Reading”.
-
Check if any DTC is detected in “Self Diagnostic Result” of “TRANSMISSION”.
Is any DTC detected?
YES >>Perform diagnosis on the detected DTC and repair or replace the malfunctioning parts. DTC Index
NO >>GO TO 3 .
-
-
CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) SELF-DIAGNOSIS RESULTS
-
Perform “All DTC Reading”.
-
Check if any DTC is detected in “Self Diagnostic Result” of “ABS”.
Is any DTC detected?
YES >>Perform diagnosis on the detected DTC and repair or replace the malfunctioning parts. DTC Index
NO >>Replace the ADAS control unit 2. Removal and Installation
-
Other materials:
P2770-00 Torque Converter Clutch
Dtc Description
DTC Description
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis
content)
DTC detection
conditi ...
Side Radar Left (side Radar Lh)
C1e00-44 Control Unit
Dtc Description
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis
content)
DTC detecti ...
C1711-7b Low Tire Pressure Fl
Dtc Description
DTC Description
Note:
The Signal Tech II Tool [– (NI-50190)] can be used
to perform the following functions: Refer to the Signal Tech II User
Guide for additional information.
Activate and display TPMS sensor IDs
Display tire pressure rep ...