Factory-style information for owners and repair work

Nissan Sentra techinfo

Find Nissan Sentra owner information, maintenance instructions, technical references, service procedures and useful repair pages in one clean online library.

Nissan Sentra B18 (2020-2025) Service Manual: C1f00-44 Control Unit

Dtc Description

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content)

DTC detection condition

 

C1F00

44

CONTROL UNIT

(Control unit)

Diagnosis condition

When engine is running

Signal (terminal)

Threshold

ADAS control unit 2 internal malfunction

Diagnosis delay time

1 second or less

POSSIBLE CAUSE

ADAS control unit 2

FAIL-SAFE

The following systems are canceled.

  • Nissan Sentra Vehicle-to-vehicle distance control mode

  • Conventional (fixed speed) cruise control mode

  • AEB

  • LDW

  • TSR

  • BSW

  • I-DA

  • RCTA

  • I-FCW

  • RAB

Confirmation Procedure

Confirmation Procedure
  1. PERFORM DTC CONFIRMATION PROCEDURE

    1. Start the engine.

    2. Perform “All DTC Reading” with CONSULT.

    3. Check if the “C1F00-44” is detected as the current malfunction in “Self Diagnostic Result” of “ICC/ADAS 2”.

    Is “C1F00-44” detected as the current malfunction?

    YES >>

    DTC Diagnosis Procedure

    NO-1 >>

    To check malfunction symptom before repair: Intermittent Incident

    NO-2 >>

    Confirmation after repair: INSPECTION END

Dtc Diagnosis Procedure

DTC Diagnosis Procedure
  1. CHECK SELF-DIAGNOSIS RESULTS

    Check if any DTC other than “C1F00-44”, is detected in “Self Diagnostic Result” of “ICC/ADAS 2”.

    Is any DTC detected?

    YES >>

    Perform diagnosis on the detected DTC and repair or replace the malfunctioning parts. DTC Index

    NO >>

    Replace the ADAS control unit 2. Removal and Installation

    Dtc/circuit Diagnosis
    ...

    Other materials:

    Torque Rod
    Exploded View Exploded View CVT Models 1. Engine mounting insulator (LH) 2. Engine mounting insula ...

    Engine Oil Pressure Sensor
    Component Inspection Component Inspection CHECK EOP SENSOR Turn ignition switch OFF. Disconnect EOP sensor harness connector. Check resistance between EOP sensor connector termi ...

    Environmental factors influence the rate of corrosion
    Moisture Accumulation of sand, dirt and water on the vehicle body underside can accelerate corrosion. Wet floor coverings will not dry completely inside the vehicle and should be removed for drying to avoid floor panel corrosion. Relative humidity Corrosion will be accelerated in areas of h ...