Nissan Sentra B18 (2020-2025) Service Manual: Basic Inspection. Additional Service When Replacing 8ch Can Gateway
Additional Service When Replacing 8ch Can Gateway
Work Procedure
Work Procedure
DESCRIPTION
When replacing 8CH CAN gateway, the following procedure must be performed.
WORK PROCEDURE
-
SAVE 8CH CAN GATEWAY PART NUMBER
CONSULT ConfigurationRead out the part number from the old 8CH CAN gateway and save the number, following the programming instructions. Refer to “CONSULT Operation Manual”.
Note:
-
The 8CH CAN gateway part number is saved in CONSULT.
-
Even when 8CH CAN gateway part number is not saved in CONSULT, go to 2.
GO TO 2.
-
-
REPLACE 8CH CAN GATEWAY
Replace 8CH CAN gateway. Refer to Removal and Installation.
>>GO TO 3.
-
PERFORM 8CH CAN GATEWAY PROGRAMMING
CONSULT ConfigurationPerform the 8CH CAN gateway programming. Refer to “CONSULT Operation Manual”.
>>GO TO 4.
-
CHECK ALL ECU SELF-DIAGNOSIS RESULTS
-
Erase all ECU self-diagnosis results using CONSULT.
-
Turn the ignition switch OFF.
-
Turn the ignition switch ON and wait for 2 seconds or more.
-
Check that all ECU self-diagnosis results have no DTC (e.g. U1000 and U1001) of CAN communication.
WORK END
-
Other materials:
Component Parts
Chassis Control System
Component Parts Location
Component Parts
Location
A.
View with steering wheel removed
No ...
Precaution for Supplemental Restraint System (srs) "air Bag" and "seat Belt Pre-Tensioner"
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as
“AIR BAG” and “SEAT BELT PRE-TENSIONER”,
used along with a front seat belt, helps to reduce the risk or
severity of injury to the driver and fron ...
Frp Control System
Component Inspection
Component Inspection
CHECK HIGH PRESSURE FUEL PUMP-1
Turn ignition switch OFF.
Disconnect high pressure fuel pump
harness connector.
Check the resistance between high
...