Nissan Sentra B18 (2020-2025) Service Manual: Basic Inspection
Diagnosis and Repair Work Flow
Work Flow
Work Flow
OVERALL SEQUENCE
DETAILED FLOW
-
INTERVIEW FOR MALFUNCTION
It is also important to clarify the customer concerns before starting the inspection. Interview the customer about the concerns carefully and understand the symptoms fully.
Note:
The customers are not professionals. Never assume that “maybe the customer means···� or “maybe the customer mentioned this symptom�.
>>GO TO 2.
-
SELF-DIAGNOSIS WITH CONSULT
-
Perform “All DTC Reading� with CONSULT.
-
Check if the DTC is detected on the self-diagnosis results of following.
-
“ICC/ADAS 2�
-
“SONAR�
-
Is any DTC detected?
YES >>Record or print self-diagnosis results and freeze frame data (FFD). GO TO 5.
NO >>GO TO 3.
-
-
ACTION TEST
Perform RAB system action test to check the operation status. Refer to Work Procedure.
Check if any other malfunctions occur.
>>GO TO 4.
-
SYMPTOM DIAGNOSIS
Perform the applicable diagnosis according to the diagnosis chart by symptom. Refer to Symptom Table.
>>GO TO 6.
-
TROUBLE DIAGNOSIS BY DTC
- Erase self-diagnostic results.
- Ignition switch OFF → ON.
CAUTION:
Be sure to wait of 10 seconds after turning ignition switch OFF or ON.
-
Check the DTC in the self-diagnosis results.
-
Perform trouble diagnosis for the detected DTC following.
-
“ICC/ADAS 2�: Refer to DTC Index.
-
“SONAR�: Refer to DTC Index.
-
If “DTC: U1000–01� is detected, first diagnose the CAN communication system.
>>GO TO 6.
-
MALFUNCTIONING PART REPAIR
Repair or replace the identified malfunctioning parts.
>>GO TO 7.
-
REPAIR CHECK (SELF-DIAGNOSIS WITH CONSULT)
-
Erases self-diagnosis results.
-
Perform “All DTC Reading� again after repairing or replacing the specific items.
-
Check if any DTC is detected in self-diagnosis results of following.
-
“ICC/ADAS 2�
-
“SONAR�
-
Is any DTC detected?
YES >>GO TO 5.
NO >>GO TO 8.
-
-
REPAIR CHECK (ACTION TEST)
Perform the RAB system action test. Check that the malfunction symptom is solved or no other symptoms occur.
Is there a malfunction symptom?
YES >>GO TO 4.
NO >>INSPECTION END
Action Test
Work Procedure
Work Procedure
Always perform the rear automatic braking system action test to check that the system operates normally after replacing the ADAS control unit or repairing any rear automatic braking system malfunction.
-
CHECK REAR AUTOMATIC BRAKING SYSTEM SETTING
-
Start the engine.
-
Check that the rear automatic braking system setting can be enabled/disabled on the combination meter.
INSPECTION END
-
Other materials:
Heated Steering Wheel System
Component Function Check
Component Function Check
CHECK HEATED STEERING WHEEL
SYSTEM
Check operate heated steering wheel system. Refer
to System Description.
Is the inspection result normal?
YES >>
I ...
Symptom Diagnosis. Noise, Vibration and Harshness (nvh) Troubleshooting
Noise, Vibration and Harshness (nvh) Troubleshooting
Nvh Troubleshooting Chart
NVH Troubleshooting Chart
Use the chart below to find the cause of the
symptom. The numbers indicate the order of the inspection. If
necessary, repair or replace these parts.
...
Defogger. System Description
Component Parts. Defogger System
Defogger System
Component Parts Location
Component Parts
Location
A.
A/C switch assembly
(view with component removed)
...