Nissan Sentra B18 (2020-2025) Service Manual / Driver Information & Multimedia / Audio, Visual & Navigation System :: Telematics System / Dtc/circuit Diagnosis / B2e04 Internal Battery

Nissan Sentra B18 (2020-2025) Service Manual: B2e04 Internal Battery

Dtc Description

DTC Description

DTC DETECTION LOGIC

DTC No.	CONSULT screen terms (Trouble diagnosis content)	DTC detection condition
B2E04-16	Internal battery (Internal battery)	Diagnosis condition	When ignition switch is ON
		Signal (terminal)	Internal battery remaining
		Threshold	25% or less
		Diagnosis delay time	1 second or more

POSSIBLE CAUSE

Internal battery discharged

FAIL-SAFE

Telematics system does not operate

Confirmation Procedure

Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE
1. CONSULT
  1. Ignition switch ON.
  2. Ignition switch OFF and wait at least 30 seconds.
  3. Ignition switch ON and wait at least 30 seconds or more.
  4. Select “Self Diagnostic Result” mode of “IVC”.
  5. Check DTC.
Is DTC B2E04–16 detected?
YES>>
Proceed to DTC Diagnosis Procedure.
NO>>
To check malfunction symptom before repair: Refer to Intermittent Incident.
NO>>
Confirmation after repair: Inspection End.

Dtc Diagnosis Procedure

DTC Diagnosis Procedure

INTERNAL BATTERY CHARGING
1. Ignition switch ON or engine idling more than one hour for internal battery charging of TCU.
YES >>
GO TO 2.
PERFORM CONFIRMATION PROCEDURE AGAIN
1. CONSULT
  1. Ignition switch ON.
  2. Erase DTC.
  3. Perform DTC confirmation procedure again. Refer to DTC Confirmation Procedure.
Is DTC B2E04–16 detected again?
YES>>
Replace TCU. Refer to Removal and Installation.
NO>>
Inspection End.

 B2e01 Internal Battery

Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B2E01-16 Internal battery (Internal battery)...

 B2e05 Air Bag Can

Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B2E05-29 Air Bag CAN (Air Bag CAN) Diagnosis...

Other materials:

Diagnosis System (a/c Amp.)
Diagnosis Description Diagnosis Description CONSULT performs the following functions via CAN communication with A/C amp.: Diagnostic mode CGW Status Descrip ...

B107e-52 Air Bag Lock Mode
Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition ...

Clutch Point Learning
Description Description TCM memorizes a clutch point (engagement timing), and this enables accurate control. For work procedure, refer to Work Procedure. Work Procedure Work Procedure CLUTCH POINT LEARNING With CONSULT Start the engine. ...