Nissan Sentra B18 (2020-2025) Service Manual / Driver Information & Multimedia / Audio, Visual & Navigation System :: Telematics System / Dtc/circuit Diagnosis / B2e01 Internal Battery

Nissan Sentra B18 (2020-2025) Service Manual: B2e01 Internal Battery

Dtc Description

DTC Description

DTC DETECTION LOGIC

DTC No.	CONSULT screen terms (Trouble diagnosis content)	DTC detection condition
B2E01-16	Internal battery (Internal battery)	Diagnosis condition	When ignition switch is ON
		Signal (terminal)	Internal battery remaining
		Threshold	25% or less
		Diagnosis delay time	1 second or more
B2E01-4A		Diagnosis condition	When ignition switch is ON
		Signal (terminal)	Internal battery power supply
		Threshold	Internal battery degradation
		Diagnosis delay time	1 second or more
B2E01-4B		Diagnosis condition	When ignition switch is ON
		Signal (terminal)	Internal battery temperature
		Threshold	100 °C (212 °F) or more
		Diagnosis delay time	1 second or more
B2E01-96		Diagnosis condition	When ignition switch is ON
		Signal (terminal)	Internal battery
		Threshold	Internal battery abnormality
		Diagnosis delay time	1 second or more

POSSIBLE CAUSE

16: Internal battery discharged
4A: Internal battery power supply approaching its end of life
4B: Internal battery temperature sensed above 100 °C (212 °F)
96:
- Internal battery disconnected
- Internal battery abnormality
- Internal battery connector error

FAIL-SAFE

Telematics system does not operate

Confirmation Procedure

Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE
1. CONSULT
  1. Ignition switch ON.
  2. Ignition switch OFF and wait at least 30 seconds.
  3. Ignition switch ON and wait at least 30 seconds or more.
  4. Select “Self Diagnostic Result” mode of “IVC”.
  5. Check DTC.
Is DTC B2E01 detected?
YES>>
Proceed to DTC Diagnosis Procedure.
NO>>
To check malfunction symptom before repair. Refer to Intermittent Incident.
NO>>
Confirmation after repair: Inspection End.

Dtc Diagnosis Procedure

DTC Diagnosis Procedure

DETERMINE MALFUNCTION TYPE
1. CONSULT
  1. Ignition switch ON.
  2. Ignition switch OFF and wait at least 30 seconds.
  3. Ignition switch ON and wait at least 30 seconds or more.
  4. Select “Self Diagnostic Result” mode of “IVC”.
  5. Check DTC.
Is DTC B2E01–16, 4A, 4B or 96 detected?
YES>>
16 – GO TO 2.
YES>>
4A or 96 – GO TO 4.
YES>>
4B – GO TO 3.
NO>>
Refer to Intermittent Incident.
INTERNAL BATTERY CHARGING
1. Ignition switch ON or engine idling more than one hour for internal battery charging of TCU.
YES >>
GO TO 4.
DECREASE TCU TEMPERATURE
1. 1. Move the Nissan Sentra vehicle to a cool place.
  2. Ignition switch OFF and wait until the temperature around TCU cools down.
YES >>
GO TO 4.
PERFORM CONFIRMATION PROCEDURE AGAIN
1. CONSULT
  1. Ignition switch ON.
  2. Erase DTC.
  3. Perform DTC confirmation procedure again. Refer to DTC Confirmation Procedure.
Is DTC B2E01 detected again?
YES >>
Replace TCU. Refer to Removal and Installation.
NO >>
Inspection End.

 Dtc/circuit Diagnosis

 B2e04 Internal Battery

Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B2E04-16 Internal battery (Internal battery)...

Other materials:

Bluetooth connections screen
" " (back) key Bluetooth tab Connections screen "Add New" key " " (settings) key " " (info) key " " (Bluetooth Audio connection) key " " (Bluetooth Hands-Free Phone System connection) key U ...

P0136 O2 Sensor 2 Bank 1
Dtc Description DTC Description The heated oxygen sensor 2 has a much longer switching time between rich and lean than the air fuel ratio (A/F) sensor 1. The oxygen storage capacity of the three way catalyst (manifold) causes the longer switching time. MALFUNCTION A To judge the ...

Basic Inspection
Diagnosis and Repair Workflow Work Flow Work Flow OVERALL SEQUENCE DETAILED FLOW GET INFORMATION FOR SYMPTOM Get detailed information from the customer about the symptom (the condition and the environment when the incident/ma ...