Nissan Sentra B18 (2020-2025) Service Manual: B2205-29 Vehicle Speed
Dtc Description
DTC Description
DTC DETECTION LOGIC
|
DTC No. |
CONSULT screen terms (Trouble diagnosis content) |
DTC detected condition |
||
|---|---|---|---|---|
|
B2205-29 |
SPEED METER (Speed meter) |
Diagnosis condition |
When ignition switch is ON. |
|
|
Signal (terminal) |
Nissan Sentra Vehicle speed display signal |
|||
|
Threshold |
An abnormal Nissan Sentra vehicle speed signal is input from ECM |
|||
|
Diagnosis delay time |
2 seconds or more |
|||
POSSIBLE CAUSE
-
ECM
-
ABS actuator and electric unit (control unit)
-
Wheel sensor
FAIL-SAFE
Reset to zero of the speedometer by suspending communication.
Confirmation Procedure
Confirmation Procedure
-
PERFORM DTC CONFIRMATION PROCEDURE
-
CONSULT-
Ignition switch ON.
-
Select “Self Diagnostic Result” mode of “METER/M&A”.
-
Is DTC B2205-29 detected?
YES >>Refer to DTC Diagnosis Procedure.
NO >>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO >>Confirmation after repair: Inspection End.
-
Dtc Diagnosis Procedure
DTC Diagnosis Procedure
-
PERFORM SELF DIAGNOSTIC RESULT OF ECM
-
CONSULTSelect “Self Diagnostic Result” mode of “ENGINE”.
Is DTC detected?
YES >>Perform diagnosis procedure on the detected DTC. Refer to DTC Index.
NO >>GO TO 2.
-
-
PERFORM SELF DIAGNOSTIC RESULT OF ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)
-
CONSULTSelect “Self Diagnostic Result” mode of “ABS”.
Is DTC detected?
YES >>Perform diagnosis procedure on the detected DTC. Refer to DTC Index.
NO >>Inspection End.
-
Other materials:
Door Lock
Consult Function (bcm - Door Lock)
CONSULT Function (BCM - DOOR LOCK)
DATA MONITOR
Note:
The following table includes information (items)
inapplicable to this Nissan Sentra vehicle. For information (items) applicable to
this vehicle, refer to CONSULT display items.
...
Fuel Pump
Component Inspection
Component Inspection
CHECK FUEL PUMP
Turn ignition switch OFF.
Disconnect “fuel level sensor
unit and fuel pump” harness connector.
Check the resistance between
...
Frp Control System
Component Inspection
Component Inspection
CHECK HIGH PRESSURE FUEL PUMP-1
Turn ignition switch OFF.
Disconnect high pressure fuel pump
harness connector.
Check the resistance between high
...