Dtc Description
DTC DETECTION LOGIC
|
DTC No. |
CONSULT screen items (Trouble diagnosis content) |
DTC Detection Condition |
|
|---|---|---|---|
|
B1041-82 |
Nissan Sentra Vehicle speed signal (Vehicle speed signal) |
Diagnosis condition |
When ignition switch is ON. |
|
Signal (terminal) |
CAN communication signal |
||
|
Threshold |
Error signal that is received from ABS actuator and electric unit (control unit) |
||
|
Diagnosis delay time |
2 seconds or more. |
||
POSSIBLE CAUSE
ABS actuator and electric unit (control unit)
Air bag diagnosis sensor unit
FAIL-SAFE
—
Confirmation Procedure
CHECK DTC PRIORITY
If DTC B1041-82 is displayed with Network-DTC, first perform the trouble diagnosis for Network-DTC.
Is applicable DTC detected?
YES>>Perform diagnosis of applicable. Refer to DTC Index.
NO>>GO TO 2.
CHECK SELF DIAGNOSTIC RESULT
CONSULT
Ignition switch ON.
Select “Self Diagnostic Result” mode of “AIR BAG”.
Check for DTC.
Is malfunctioning part detected?
YES >>Refer to DTC Diagnosis Procedure.
NO >>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO >>Confirmation after repair: Inspection End.
Dtc Diagnosis Procedure
Warning:
Before servicing, ignition switch OFF, disconnect battery negative terminal, and wait at least 3 minutes or more (to discharge backup capacitor).
Never use an unspecified tester or other measuring device.
CHECK DTC PRIORITY
If DTC B1041-82 is displayed with Network-DTC, first perform the trouble diagnosis for Network-DTC.
Is applicable DTC detected?
YES>>Perform diagnosis of applicable. Refer to DTC Index.
NO>>GO TO 2.
CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) SELF DIAGNOSTIC RESULT
Check if any DTC is detected in “Self Diagnostic Result” of “ABS”.
Is any DTC detected?
YES>>Perform diagnosis on the detected DTC and repair or replace the malfunctioning parts. Refer to DTC Index.
NO>>Replace air bag diagnosis sensor unit. Refer to Removal and Installation.
B1040-22 Vehicle SpeedMain power window and door lock/ unlock switch
Removal and Installation
REMOVAL
Release the pawls using a suitable tool and lift the main power window
and door lock/unlock switch and
finisher as an assembly and remove.
Disconnect the harness connector from the main power window and door
lock/unlock switch.
Release the four pawls ...
B2267-29 Engine Speed
Dtc Description
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis
content)
DTC detected condition
...
Hoses
HOSE REMOVAL AND INSTALLATION
To prevent damage to
rubber hose, do not pry off rubber hose with
tapered tool or screwdriver.
To reinstall the
rubber hose securely, make sure that hose insertion
length and orientation is correct. (If tube is equipped with hose ...