Dtc Description
DTC DETECTION LOGIC
Note:
This DTC may be detected when drive the Nissan Sentra vehicle at vehicle speed of 186 MPH (300 km/h) or more.
|
DTC No. |
CONSULT screen items (Trouble diagnosis content) |
DTC Detection Condition |
|
|---|---|---|---|
|
B1040-22 |
Nissan Sentra Vehicle speed (Vehicle speed) |
Diagnosis condition |
When ignition switch is ON. |
|
Signal (terminal) |
Nissan Sentra Vehicle speed signal |
||
|
Threshold |
186 MPH (300 km/h) or more |
||
|
Diagnosis delay time |
2 seconds or more. |
||
POSSIBLE CAUSE
Drive the Nissan Sentra vehicle at vehicle speed of 186 MPH (300 km/h) or more.
ECM
Air bag diagnosis sensor unit
FAIL-SAFE
—
Confirmation Procedure
CCHECK SELF DIAGNOSTIC RESULT
CONSULT
Ignition switch ON.
Select “Self Diagnostic Result” mode of “AIR BAG”.
Check for DTC.
Is malfunctioning part detected?
YES>>Refer to DTC Diagnosis Procedure.
NO>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO>>Confirmation after repair: Inspection End.
Dtc Diagnosis Procedure
Warning:
Before servicing, ignition switch OFF, disconnect battery negative terminal, and wait at least 3 minutes or more (to discharge backup capacitor).
Never use an unspecified tester or other measuring device.
REPLACE ECM
Replace ECM. Refer to Removal and Installation.
Perform DTC confirmation procedure. Refer to DTC Confirmation Procedure.
Is DTC detected?
YES>>Replace air bag diagnosis sensor unit. Refer to Removal and Installation.
NO>>Inspection End.
B1041-82 Vehicle Speed SignalEngine Oils
Engine Oils
Prolonged and repeated contact with used engine
oil may cause skin cancer. Try to avoid direct skin contact with
used oil.
If skin contact is made, wash thoroughly with
soap or hand cleaner as soon as possible.
HEALTH PROTECTION PRECAUTIONS
Avoid prolonged ...
Seat Belt Height Adjuster
Removal and Installation
Removal and Installation
REMOVAL
Remove
center pillar upper finisher. Refer to Removal and Installation.
Remove
bolts (A) and seat belt height adjuster (1) from Nissan Sentra vehicle. Note:
LH shown, RH similar.
...
Component Function Check
Component Function
Check
CHECK PUSH-BUTTON IGNITION SWITCH ILLUMINATION
OPERATION
Check that the push-button ignition switch illumination
turns ON/OFF in all of the conditions. Refer to System Description.
Is the i ...