Nissan Sentra B18 (2020-2025) Service Manual / Restraints / Srs Air Bag Control System :: Dtc/circuit Diagnosis / Air Bag (air Bag Diagnosis Sensor Unit) / B0001-09 Driver Air Bag Module

Nissan Sentra B18 (2020-2025) Service Manual: B0001-09 Driver Air Bag Module

Dtc Description

DTC Description

DTC DETECTION LOGIC

DTC No.	CONSULT screen items (Trouble diagnosis content)	DTC Detection Condition
B0001-09	DRIVER AIR BAG MODULE (Driver Frontal Stage 1 Deployment Control)	Diagnosis condition	When ignition switch is ON.
		Signal (terminal)	Driver air bag module signal
		Threshold	Driver air bag module circuit is shorted to other (including the spiral cable)
		Diagnosis delay time	2 seconds or more.

POSSIBLE CAUSE

Connection malfunction or short circuit of harness and connector
Internal malfunction of driver air bag module
Internal malfunction of air bag diagnosis sensor unit

FAIL-SAFE

—

Dtc Confirmation Procedure

DTC Confirmation Procedure

CHECK SELF DIAGNOSTIC RESULT
1. CONSULT
  1. Ignition switch ON.
  2. Select "Self Diagnostic Result" mode of "AIR BAG".
Is malfunctioning part detected?
YES >>
Refer to DTC Diagnosis Procedure.
NO >>
To check malfunction symptom before repair: Refer to Intermittent Incident.
NO >>
Confirmation after repair: Inspection End.

Dtc Diagnosis Procedure

DTC Diagnosis Procedure

Warning:

Before servicing, ignition switch OFF, disconnect battery negative terminal, and wait at least 3 minutes or more (to discharge backup capacitor).

Never use an unspecified tester or other measuring device.

CHECK HARNESS CONNECTOR
1. Check the harness connector.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Replace harness connector.
CHECK WIRING HARNESS
1. Check the wiring harness externals.
Is the inspection result normal?
YES>>
GO TO 3.
NO>>
Replace wiring harness.
REPLACE SPIRAL CABLE
1. 1. Replace spiral cable. Refer to Removal and Installation.
  2. Perform DTC confirmation procedure. Refer to DTC Confirmation Procedure.
Is DTC detected?
YES>>
GO TO 4.
NO>>
Inspection End.
REPLACE DRIVER AIR BAG MODULE
1. 1. Replace driver air bag module. Refer to Removal and Installation.
  2. Perform DTC confirmation procedure. Refer to DTC Confirmation Procedure.
Is DTC detected?
YES>>
GO TO 5.
NO>>
Inspection End.
REPLACE AIR BAG DIAGNOSIS SENSOR UNIT
1. 1. Replace air bag diagnosis sensor unit. Refer to Removal and Installation.
  2. Perform DTC confirmation procedure. Refer to DTC Confirmation Procedure.
Is DTC detected?
YES>>
GO TO 1.
NO>>
Inspection End.

 Air Bag (air Bag Diagnosis Sensor Unit)

 B0002-09 Driver Air Bag Module

Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition B0002–09 DRIVER AIR BAG MODULE 2 [SHORT] D...

Other materials:

Sonar System. Symptom Diagnosis. Sonar System. Symptom Table
Sonar System. Symptom Table Symptom Table Symptom Table Symptom Possible cause Reference page Malfunction is detected in ...

Removal and Installation
Combination Meter Exploded View Exploded View 1. Front cover 2. Combination meter ...

Diagnosis System (av Control Unit)
Description Description The AV control unit on board diagnosis performs the following functions listed in the table below: Mode Description Self D ...