Nissan Sentra manuals

Nissan Sentra Service Manual: ASCD Indicator

Component Function Check

1.CHECK ASCD INDICATOR FUNCTION

Check ASCD indicator under the following conditions.

ASCD INDICATOR

CONDITION

SPECIFICATION

CRUISE LAMP
  • Ignition switch: ON
  • MAIN switch: Pressed at the 1st time → at the 2nd time
ON → OFF
SET LAMP
  • MAIN switch: ON
  • When vehicle speed is between 38 km/h (24 MPH) and 160 km/h (100 MPH)
  • ASCD: Operating
ON
  • ASCD: Not operating
OFF

Is the inspection result normal? YES >> INSPECTION END

NO >> Proceed to EC-449, "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK DTC

Check that DTC UXXXX is not displayed.

Is the inspection result normal? YES >> GO TO 2.

NO >> Perform trouble diagnosis for DTC UXXXX.

2.CHECK DTC WITH COMBINATION METER

Check DTC with combination meter. Refer to MWI-26, "DTC Index".

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair or replace error-detected parts.

3.CHECK INTERMITTENT INCIDENT

Check intermittent incident. Refer to GI-39, "Intermittent Incident".

Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-77, "Removal and Installation".

NO >> Repair or replace error-detected parts.

Brake pedal position switch
Component Function Check 1.CHECK BRAKE PEDAL POSITION SWITCH FUNCTION With CONSULT Turn ignition switch ON. Select “ENGINE” using CONSULT. Select “BRAKE SW1” in “DA ...

Fuel injector
Component Function Check 1.INSPECTION START Turn ignition switch to START. Is any cylinder ignited? YES >> GO TO 2. NO >> Proceed to EC-450, "Diagnosis Procedure". 2.CH ...

Other materials:

P0300, P0301, P0302, P0303, P0304 Misfire
DTC Logic DTC DETECTION LOGIC When a misfire occurs, engine speed will fluctuate. If the engine speed fluctuates enough to cause the crankshaft position (CKP) sensor (POS) signal to vary, ECM can determine that a misfire is occurring. Sensor Input signal to ECM ECM function ...

Dtc/circuit diagnosis
Power supply and ground circuit Audio unit Audio unit : diagnosis procedure Regarding Wiring Diagram information, refer to AV-157, "Wiring Diagram". 1.Check fuse Are the fuses blown? Yes >> replace the blown fuse after repairing the affected circuit. No >> go to 2. ...

Audible reminders
Brake pad wear warning The disc brake pads have audible wear warnings. When a disc brake pad requires replacement, it makes a high pitched scraping sound when the vehicle is in motion, whether or not the brake pedal is depressed. Have the brakes checked as soon as possible if the warning sou ...

© 2014-2026 Copyright www.nisentra.com