Nissan Sentra B18 (2020-2025) Service Manual: Additional Service When Replacing 8ch Can Gateway

Nissan Sentra B18 (2020-2025) Service Manual / Electrical & Power Control / Lan System :: Can Gateway / Basic Inspection / Additional Service When Replacing 8ch Can Gateway

Work Procedure

Work Procedure

DESCRIPTION

When replacing 8CH CAN gateway, the following procedure must be performed.

WORK PROCEDURE

SAVE 8CH CAN GATEWAY PART NUMBER

CONSULT Configuration

Read out the part number from the old 8CH CAN gateway and save the number, following the programming instructions. Refer to “CONSULT Operation Manual”.
Note:
- The 8CH CAN gateway part number is saved in CONSULT.
- Even when 8CH CAN gateway part number is not saved in CONSULT, go to 2.
>>
GO TO 2.
REPLACE 8CH CAN GATEWAY

Replace 8CH CAN gateway. Refer to Removal and Installation.

>>
GO TO 3.
PERFORM 8CH CAN GATEWAY PROGRAMMING

CONSULT Configuration

Perform the 8CH CAN gateway programming. Refer to “CONSULT Operation Manual”.

>>
GO TO 4.
CHECK ALL ECU SELF-DIAGNOSIS RESULTS
1. Erase all ECU self-diagnosis results using CONSULT.
2. Turn the ignition switch OFF.
3. Turn the ignition switch ON and wait for 2 seconds or more.
4. Check that all ECU self-diagnosis results have no DTC (e.g. U1000 and U1001) of CAN communication.
>>
WORK END

Basic Inspection

...

Dtc Diagnosis [8ch Can Gateway (8ch Can Gateway)]

...

Other materials:

Ignition signal
Component Function Check 1.INSPECTION START Turn ignition switch OFF. Start engine. Does the engine start? YES >> GO TO 2. NO >> Proceed to EC-456, "Diagnosis Procedure". 2.IGNITION SIGNAL FUNCTION With CONSULT Perform вЂњPOWER BALANCEвЂќ in вЂњACT ...

Component Parts
Intelligent Cruise Control System Component Parts Location Component Parts Location A. Front bumper fascia area (view with front bumper fascia removed) ...

Spark Plug
Exploded View Exploded View 1. Ignition coil 2. Spark plug 3. Rocker ...