Nissan Sentra Service Manual: The seat belt reminder warning continues sounding, or does not sound
Description
- Seat belt reminder warning does not sound.
- Seat belt reminder warning sounds continuously.
Diagnosis procedure
1.Check seat belt warning lamp
- Turn ignition switch on.
- Check the operation of the seat belt warning lamp in the combination meter.
Is the inspection result normal? Yes >> replace combination meter. Refer to mwi-77, "removal and installation".
No >> go to 2.
2.Check seat belt buckle switch (lh) signal circuit
Check the seat belt buckle switch (lh) circuit. Refer to wcs-29, "diagnosis procedure".
Is the inspection result normal? Yes >> go to 3.
No >> repair or replace harness or connector.
3.Check seat belt buckle switch (lh)
Check the seat belt buckle switch (LH). Refer to WCS-30, "Component Inspection".
Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-77, "Removal and Installation".
NO >> Replace seat belt buckle (LH). Refer to SR-32, "Removal and Installation".
The parking brake release warning
continues sounding, or does not
sound
Description
The parking brake warning buzzer sounds continuously during vehicle
travel though the parking brake is
released.
The parking brake warning buzzer does not sound at all even tho ...
The light reminder warning does
not sound
Description
Light reminder warning chime does not sound even though headlamp is
illuminated.
Diagnosis procedure
1.Check combination meter input signal
Select the data monitor for the meter/m&am ...
Other materials:
Wheel sensor
Front wheel sensor
FRONT WHEEL SENSOR : Exploded View
Front wheel sensor
Front wheel sensor harness connector
Front
FRONT WHEEL SENSOR : Removal and Installation
CAUTION:
Be careful not to damage wheel sensor edge and sensor
rotor teeth.
When removing the front ...
Roof side molding
Exploded view
Roof side molding
Roof side molding clip
Roof panel
Body side outer panel
Adhesive tape
Removal and installation
REMOVAL
ROOF SIDE MOLDING
Release roof side molding rear side clip, using a suitable tool
(A).
Clip
Front
CAUTION:
Apply protective tape ...
C1716, C1717, C1718, C1719 Transmitter (pressure data)
DTC Logic
NOTE:
The Signal Tech II Tool (J-50190) can be used to perform the following
functions. Refer to the Signal Tech II
User Guide for additional information.
Activate and display TPMS transmitter IDs
Display tire pressure reported by the TPMS transmitter
Read TPMS DTCs
Register ...
