Nissan Sentra Service Manual: The light reminder warning does not sound
Description
Light reminder warning chime does not sound even though headlamp is illuminated.
Diagnosis procedure
1.Check combination meter input signal
Select the data monitor for the meter/m&a and check the buzzer monitor value.
Is the inspection result normal? Yes >> replace combination meter. Refer to mwi-77, "removal and installation".
No >> go to 2.
2.Check front door switch lh signal circuit
Check the front door switch lh signal circuit. Refer to dlk-102, "diagnosis procedure" (with intelligent key system) or dlk-253, "diagnosis procedure" (without intelligent key system).
Is the inspection result normal? Yes >> go to 3.
No >> repair or replace harness or connector.
3.Check front door switch lh
Check front door switch lh. Refer to dlk-103, "component inspection" (with intelligent key system) or dlk- 255, "component inspection" (without intelligent key system).
Is the inspection result normal? Yes >> replace the bcm. Refer to bcs-73, "removal and installation" (with intelligent key system) or bcs-126, "removal and installation" (without intelligent key system).
No >> replace the front door switch lh. Refer to dlk-194, "removal and installation" (with intelligent key system) or dlk-341, "removal and installation" (without intelligent key system).
The seat belt reminder warning
continues sounding, or does not
sound
Description
Seat belt reminder warning does not sound.
Seat belt reminder warning sounds continuously.
Diagnosis procedure
1.Check seat belt warning lamp
Turn ignition switch on.
Chec ...
The key warning does not sound
(without intelligent key)
Description
The key warning chime does not sound, when all of the following conditions
are fulfilled.
Key inserted into the key cylinder (key switch signal on).
Ignition switch is in acc or o ...
Other materials:
Bcm branch line circuit
Diagnosis Procedure
1.Check connector
Turn the ignition switch off.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the BCM for damage, bend and loose
connection (unit side and
connector side).
Is the inspection result normal?
YES > ...
Unit disassembly and assembly
OIL PUMP
O-ring
Oil pan (upper)
Oil level gauge guide
O-ring
Oil level gauge
Oil pump chain tensioner
Oil pump drive chain
Crankshaft sprocket
Oil pump sprocket
Oil pump
Drain plug washer
Drain plug
Oil pan (lower)
Oil filter
Connector bolt
Crankshaft position s ...
Washer switch
Description
Washer switch is integrated with combination switch (wiper and washer
switch).
Combination switch (wiper and washer switch) supplies ground and fuse #
6 supplies power for the front
washer motor to operate.
Component Inspection
Regarding wiring diagram information, ...
