Nissan Sentra manuals

Nissan Sentra Service Manual: Service information for electrical incident

Nissan Sentra Service Manual / General information / Basic inspection / Service information for electrical incident

Basic inspection
...

Work Flow
STEP DESCRIPTION STEP 1 Get detailed information about the conditions and the environment when the incident occurred. The following are key pieces of information requi ...

Other materials:

Performance test
Inspection INSPECTION PROCEDURE Connect recovery/recycling/recharging equipment (for HFC-134a) or manifold gauge. Start the engine, and set to the following condition. Test condition Maintain test condition until A/C system becomes stable. (Approximately 10 minutes) Check t ...

Operating tips
When the engine coolant temperature and outside air temperature are low, the air flow from the foot outlets may not operate for a maximum of 150 seconds. However, this is not a malfunction. After the coolant temperature warms up, air flow from the foot outlets will operate normally. ...

Wiper blade
Wiper blade WIPER BLADE : Removal and Installation REMOVAL Put the wiper arms in the service position. Turn the ignition switch ON and then OFF. Within 1 minute, activate washer switch 2 times in less than 0.5 seconds to put the wiper arms in the service position. Lift the w ...

В© 2014-2026 Copyright www.nisentra.com