Nissan Sentra Service Manual: Removal and installation
- CVT Shift selector
- Control cable
- Key interlock cable
- TCM
- AIR Breather hose
- G Sensor
- OIL PAN
- Primary speed sensor
- Secondary speed sensor
- Output speed sensor
- Differential side oil seal
- Water hose
- Plug
- CVT Oil warmer
- CVT Fluid filter
- Electric oil pump
Periodic maintenance
CVT FLUID
Inspection
FLUID LEAKAGE
Check transaxle surrounding area (oil seal and plug etc.) for fluid
leakage.
If anything is found, repair or replace damaged parts and adjust
CVT fluid ...
CVT Shift selector
Exploded View
Shift selector knob
Lock pin
Knob cover
Position indication panel
Detent switch
Shift lock unit
Park position switch
Shift selector assembly
Shift selector harne ...
Other materials:
Flywheel
Exploded View
Flywheel
Removal and Installation
REMOVAL
Remove the engine and the transaxle assembly from the vehicle, and
separate the transaxle from the
engine. Refer to TM-28, "Exploded View".
Remove flywheel.
Secure flywheel (1) using Tool (A), and remove b ...
Abs actuator and electric unit (control unit)
Exploded View
ABS actuator and electric unit (control
unit)
ABS actuator and electric unit (control
unit) harness connector
Bushing
Bracket
To master cylinder secondary side
To master cylinder primary side
To rear LH caliper
To front RH caliper
...
Service Notice or Precautions for Steering System
In case of removing steering gear assembly, make the final
tightening with grounded and unloaded vehicle
condition, and then check wheel alignment.
Observe the following precautions when disassembling.
Before disassembly, thoroughly clean the outside of the
unit.
...