Noise
RefrigerantSystem description
Component parts
Component parts location
Instrument lower finisher
Eco mode switch
The eco mode switch is installed to the instrument lower finisher.
When the ECO mode indicator lamp on the combination meter is
OFF and the ECO mode switch is pressed, the ECO mode is
active and ...
How to erase permanent DTC
Description
OUTLINE
When a DTC is stored in ECM
When a DTC is stored in ECM and MIL is ON, a permanent DTC is erased with MIL
shutoff if the same malfunction
is not detected after performing the driving pattern for MIL shutoff three times
in a raw.
*1: When the same malfunction is detec ...
Transaxle side
TRANSAXLE SIDE : Removal and Installation
Remove boot after drive shaft is removed from the vehicle.
For drive shaft removal and installation, follow the instructions bellow.
6M/T: Refer to FAX-18, "6M/T : Removal and Installation (LH)".
Except 6M/T: Refer to FAX-26, "EXCEPT ...