Nissan Sentra Service Manual: Engine cooling system
- Precaution
- Preparation
- System description
- Symptom diagnosis
- Periodic maintenance
- Removal and installation
- Service data and specifications (sds)
Service data and specifications
(SDS)
Oil pressure
*: Engine oil temperature at 80В°C (176В°F)
Oil Capacity
...
Precaution
...
Other materials:
Coil spring
Exploded View
Upper rubber seat
Coil spring
Lower rubber seat
Rear suspension beam
Front
Removal and Installation
REMOVAL
Set a suitable jack under the rear suspension beam.
CAUTION:
At this step, the jack must be set only for supporting the removal
procedure. For d ...
Thermostat and thermostat housing
Exploded View
Thermostat housing
Gasket
Rubber ring
Thermostat
Water inlet
Clamp
Radiator hose (upper)
To radiator
WARNING:
Do not remove the radiator cap when the engine is hot. Serious burns
could occur from high-pressure
engine coolant escaping from the radiator. ...
Installing front license plate
Use the following steps to mount the front license
plate:
Make holes on the plastic finisher at the
location mark (small dimple) using a 0.20 in
(5 mm) drill. Apply light pressure to the drill.
Install the license plate holder using the two
screws provided with the holder.
Mount ...
