Nissan Sentra manuals

Nissan Sentra Service Manual: Ecu diagnosis information

BCM, IPDM E/R

List of ECU Reference

Wiring diagram


Diagnosis system (ipdm e/r) (without intelligent key system)
Diagnosis Description AUTO ACTIVE TEST Description In auto active test, the IPDM E/R sends a drive signal to the following systems to check their operation. Front wiper (LO, HI) Parking la ...

Wiring diagram
Headlamp Wiring diagram Daytime light system Wiring diagram Auto light system Wiring diagram Front fog lamp Wiring diagram ...

Other materials:

Rear disc brake
Brake Burnishing CAUTION: Burnish contact surfaces between brake pads and disc rotor according to the following procedure after refinishing the disc rotor, replacing brake pads or if a soft pedal occurs at very low mileage. Be careful of vehicle speed. Brakes do not operate firmly/sec ...

Basic inspection
Component inspection Inspection AFTER A COLLISION WARNING: Inspect all seat belt assemblies including retractors and attaching hardware after any collision. NISSAN/INFINITI recommends that all seat belt assemblies in use during a collision be replaced unless the collision was minor and t ...

Multiport fuel injection system
MULTIPORT FUEL INJECTION SYSTEM : System Description SYSTEM DIAGRAM *1: ECM determines the start signal status by the signals of engine speed and battery voltage. *2: M/T models *3: CVT models *4: This sensor is not used to control the engine system under normal conditions. SYSTEM DES ...

В© 2014-2025 Copyright www.nisentra.com