Nissan Sentra Owners Manual: Cup holders

Nissan Sentra Owners Manual / Instruments and controls / Storage / Cup holders

CAUTION

Avoid abrupt starting and braking when the cup holder is being used to prevent spilling the drink. If the liquid is hot, it can scald you or your passenger.
Use only soft cups in the cup holder.

Hard objects can injure you in an accident.
Do not use bottle holder for any other objects that could be thrown about in the vehicle and possibly injure people during sudden braking or an accident.
Do not use bottle holder for open liquid containers.

Front
Front

Rear
Rear

Soft bottle holder

CAUTION

Do not use bottle holder for any other objects that could be thrown about in the vehicle and possibly injure people during sudden braking or an accident.
Do not use bottle holder for open liquid containers.

Sunglasses holder

To open the sunglasses holder, push and release. Only store one pair of sunglasses in the holder. WARNINGKeep the sunglasses holder closed while driving to prevent an accident. ...

Glove box

Open the glove box by pulling the handle. WARNINGKeep glove box lid closed while driving to help prevent injury in an accident or a sudden stop. ...

Other materials:

Periodic maintenance
M/T OIL Inspection OIL LEAKAGE Make sure that gear oil is not leaking from transaxle or around it. OIL LEVEL Remove filler plug (1) and gasket from transaxle case. Check the oil level from filler plug mounting hole as shown. CAUTION: Do not start engine while checking oil level. Se ...

Moonroof does not operate properly
Diagnosis Procedure 1. Check bcm power supply and ground circuit Check BCM power supply and ground circuit. Refer to PWC-31, "BCM (BODY CONTROL SYSTEM) (WITH INTELLIGENT KEY SYSTEM) : Diagnosis Procedure". Is the inspection result normal? YES >> GO TO 2. NO >> Rep ...

Eps branch line circuit
Diagnosis procedure 1.Check connector Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the eps control unit for damage, bend and loose connection (unit side and connector side). Is the inspection result norm ...