Nissan Sentra manuals

Nissan Sentra Service Manual: Basic inspection

Preparation
Special Service Tools The actual shape of the tools may differ from those illustrated here. Commercial Service Tools ...

Steering wheel
Inspection CONDITION OF INSTALLATION Check installation condition of power steering gear assembly, front suspension, front drive shaft and steering column. Check if movement exists w ...

Other materials:

Brake pedal
Exploded View WITHOUT BRAKE PEDAL POSITION SWITCH Snap pin Brake pedal assembly Brake pedal pad Stop lamp switch Clip Clevis pin Apply multi-purpose grease. WITH BRAKE PEDAL POSITION SWITCH Snap pin Brake pedal assembly Brake pedal pad Brake pedal position switch ...

P1652 Starter motor system comm
Description ECM controls ON/OFF state of the starter relay, according to the engine and vehicle condition. ECM transmits a control signal to IPDM E/R via BCM by CAN communication. Under normal conditions, ECM controls and maintains the starter relay in OFF state during following condition: ...

Oil seal
Valve oil seal : Removal and Installation REMOVAL Rotate crankshaft, and set piston whose valve oil seal is to be removed to TDC. This will prevent valve from dropping into cylinder. CAUTION: When rotating crankshaft, be careful to avoid scarring front cover with timing chain. Re ...

В© 2014-2020 Copyright www.nisentra.com