Nissan Sentra manuals

Nissan Sentra Service Manual: Preparation

Special Service Tools

The actual shape of the tools may differ from those illustrated here.

Commercial Service Tools


Commercial Service Tools

Basic inspection


Service Notice or Precautions for Steering System
In case of removing steering gear assembly, make the final tightening with grounded and unloaded vehicle condition, and then check wheel alignment. Observe the following precautions wh ...

Basic inspection
...

Other materials:

Additional service when replacing ecm
Description When replacing ECM, the following procedure must be performed. (For details, refer to EC-135, "Work Procedure".) PROGRAMMING OPERATION NOTE: After replacing with a blank ECM, programming is required to write ECM information. Be sure to follow the procedure to perform t ...

Connector symbols
Most of connector symbols in wiring diagrams are shown from the terminal side. Connector symbols shown from the terminal side are enclosed by a single line and followed by the direction mark. Connector symbols shown from the harness side are enclosed by a double line and followed by the ...

P0139 HO2S2
DTC Logic DTC DETECTION LOGIC The heated oxygen sensor 2 has a much longer switching time between rich and lean than the air fuel ratio (A/F) sensor 1. The oxygen storage capacity of the three way catalyst 1 causes the longer switching time. To judge the malfunctions of heated oxygen sensor 2, ...

В© 2014-2020 Copyright www.nisentra.com