Nissan Sentra manuals

Nissan Sentra Service Manual: Door mirror remote control switch

Removal and Installation

Removal

  1. Remove the instrument finisher D. Refer to IP-14, "Exploded View".
  2. Using suitable tool (a) release the pawls and remove the door mirror remote control switch (2) from the switch bracket (1).

Pawl


Installation


Installation

Installation is in the reverse order of removal.

Door mirror
Exploded view Door mirror cover (with side turn signal lamp) Door mirror housing Door mirror actuator Glass mirror Door mirror cover (without side turn signal lamp) : Pawl Doo ...

Exterior lighting system
...

Other materials:

Vehicle identification number (VIN) plate
The vehicle identification number (VIN) plate is attached as shown. This number is the identification for your vehicle and is used in the vehicle registration. Vehicle identification number (chassis number) The vehicle identification number is located as shown. Engine serial number ...

Coil spring
Exploded View Upper rubber seat Coil spring Lower rubber seat Rear suspension beam Front Removal and Installation REMOVAL Set a suitable jack under the rear suspension beam. CAUTION: At this step, the jack must be set only for supporting the removal procedure. For d ...

Thermostat and thermostat housing
Exploded View Thermostat housing Gasket Rubber ring Thermostat Water inlet Clamp Radiator hose (upper) To radiator WARNING: Do not remove the radiator cap when the engine is hot. Serious burns could occur from high-pressure engine coolant escaping from the radiator. ...

В© 2014-2026 Copyright www.nisentra.com