Nissan Sentra manuals

Nissan Sentra Service Manual: Basic inspection

System description
Noise, vibration and harshness (NVH) troubleshooting NVH Troubleshooting Chart Use the chart below to find the cause of the symptom. If necessary, repair or replace these parts. ×: Appl ...

Brake pedal
Inspection BRAKE PEDAL HEIGHT Check the brake pedal height (H1) between the dash lower panel (1) and the brake pedal upper surface. Brake pedal height (H1) : Refer to BR-54, "Brake Pedal" ...

Other materials:

DTC/circuit diagnosis
U1000 can comm Description Refer to LAN-7, "CAN COMMUNICATION SYSTEM : System Description". Dtc logic DTC DETECTION LOGIC NOTE: U1000 can be set if a module harness was disconnected and reconnected, perhaps during a repair. Confirm that there are actual CAN diagnostic symptoms a ...

CD care and cleaning
Handle a CD by its edges. Do not bend the disc. Never touch the surface of the disc. Always place the discs in the storage case when they are not being used. To clean a disc, wipe the surface from the center to the outer edge using a clean, soft cloth. Do not wipe the disc using ...

P1650 Starter motor relay 2
Description ECM controls ON/OFF state of the starter relay, according to the engine and vehicle condition. ECM transmits a control signal to IPDM E/R via BCM by CAN communication. Under normal conditions, ECM controls and maintains the starter relay in OFF state during following condition: ...

В© 2014-2026 Copyright www.nisentra.com