Nissan Sentra manuals

Nissan Sentra Service Manual: Auto operation does not operate

Diagnosis Procedure

1. Perform initialization procedure

Perform initialization procedure.

Refer to rf-18, "additional service when replacing control unit : special repair requirement".

Is the inspection result normal? Yes >> inspection end.

No >> perform basic inspection. Refer to rf-16, "work flow".

Moonroof does not operate properly
Diagnosis Procedure 1. Check bcm power supply and ground circuit Check BCM power supply and ground circuit. Refer to PWC-31, "BCM (BODY CONTROL SYSTEM) (WITH INTELLIGENT KEY SYSTEM) : Diag ...

Moonroof does not operate antipinch function
Diagnosis Procedure 1. Perform initialization procedure Perform initialization procedure. Refer to rf-18, "additional service when replacing control unit : special repair requirement" ...

Other materials:

Rear drum brake
Brake Burnishing CAUTION: Burnish contact surfaces between brake drum and brake lining according to the following procedure after refinishing or replacing brake drum, or if a soft pedal occurs at very low mileage. Be careful of vehicle speed because the brake does not operate firml ...

Drive belt
Automatic tensioner Generator Water pump Air conditioner compressor Crankshaft pully WARNINGBe sure the ignition switch is in the OFF or LOCK position before servicing drive belt. The engine could rotate unexpectedly. Visually inspect the belt for signs of ...

Washer nozzle & tube
Exploded view Check valve Washer tube Washer tank Washer pump Washer nozzle Clip Washer nozzle Washer nozzle : removal and installation REMOVAL Disconnect the washer nozzle from the hood by pushing on the nozzle in the order and direction shown. Disconnect the ...

В© 2014-2026 Copyright www.nisentra.com