Nissan Sentra Service Manual: Roof
- Precaution
- Preparation
- System description
- Ecu diagnosis information
- Wiring diagram
- Basic inspection
- Dtc/circuit diagnosis
- Symptom diagnosis
- Removal and installation
- Unit disassembly and assembly
Rear power window switch
Removal and Installation
REMOVAL
Release the pawls using a suitable tool and lift the rear power window
switch and finisher as an assembly
and remove
Disconnect the harness connector from ...
Precaution
...
Other materials:
General Precautions
Always use a 12 volt battery as power source.
Do not attempt to disconnect battery cables while engine is
running.
Before connecting or disconnecting the ECM harness connector,
turn ignition switch OFF and disconnect negative battery
cable. Failure to do so may damage the ECM because
...
Wiper blade
Wiper blade
WIPER BLADE : Removal and Installation
REMOVAL
Put the wiper arms in the service position.
Turn the ignition switch ON and then OFF.
Within 1 minute, activate washer switch 2 times in less than 0.5 seconds
to put the wiper arms in the service
position.
Lift the w ...
RearView Monitor (if so equipped)
When the shift lever is shifted into the R (Reverse)
position, the monitor display shows the
view to the rear of the vehicle.
WARNINGFailure to follow the warnings and
instructions
for proper use of the RearView
Monitor could result in serious injury or
death.
The Rear ...
