Nissan Sentra Service Manual: Rear power window switch
Removal and Installation
REMOVAL
- Release the pawls using a suitable tool and lift the rear power window switch and finisher as an assembly and remove
- Disconnect the harness connector from the rear power window switch.
- Release the pawl (one on each side) using a suitable tool, then separate the rear power window switch (1) from the rear power switch finisher (2).
: Pawl
CAUTION:
Do not bend back the pawls on the switch finisher too far or breakage may occur.
INSTALLATION
Installation is in the reverse order of removal.
Power window and door lock/unlock switch RH
Removal and Installation
REMOVAL
Release the pawls using a suitable tool and lift the power window and
door lock/unlock switch RH and finisher
as an assembly and remove.
Disconnect the har ...
Roof
...
Other materials:
Ignition coil
Exploded View
Ignition coil
Spark plug
Rocker cover
Removal and Installation
REMOVAL
Remove the engine room cover. Refer to EM-24, "Exploded View".
Disconnect the harness connector from the ignition coil.
Remove the ignition coil.
CAUTION:
Do not drop or shock i ...
Diagnosis system (BCM)
Common item
Common item : consult function (bcm -
common item)
Application item
Consult performs the following functions via can communication with bcm.
Direct diagnostic mode
Description
ECU identification
The bcm part number is displayed.
Self Diagnostic Result
...
NISSAN vehicle immobilizer system
The NISSAN Vehicle Immobilizer system will not
allow the engine to start without the use of the
registered key.
If the engine fails to start using a registered key
(for example, when interference is caused by
another registered key, an automated toll road
device or automatic payment device o ...
