Nissan Sentra B18 (2020-2025) Service Manual: Work Procedure

Nissan Sentra B18 (2020-2025) Service Manual / Driver Information & Multimedia / Sonar System :: Basic Inspection / Configuration (sonar Control Unit) / Work Procedure

Work Procedure

Description

Vehicle specification needs to be written with CONSULT after replacing sonar control unit.

Work Procedure (Before Replacement)

SAVING Nissan Sentra Vehicle SPECIFICATION
1. CONSULT
  
  Read/save the current Nissan Sentra vehicle specification in CONSULT according to the configuration procedure in CONSULT operation manual.
  Note:
  - “TYPE ID” is saved in CONSULT for sonar control unit.
  - “TYPE ID” means the parts number (Nissan Sentra vehicle specification) stored in the sonar control unit.
>>
Work End.

Work Procedure (After Replacement)

CHECKING SONAR CONTROL UNIT TYPE ID
1. CONSULT
  1. Perform ECU setting according to the “CONFIGURATION” procedure in the “CONSULT Operation Manual”. Refer to CONSULT Operation Manual.
  2. Check if the Type ID of the sonar control unit is displayed on the CONSULT screen.
Is Type ID displayed?
YES >>
GO TO 2.
NO >>
GO TO 3.
WRITING Nissan Sentra Vehicle SPECIFICATION
1. CONSULT
  
  Follow the procedure displayed in CONSULT for writing the saved Nissan Sentra vehicle specification data to the sonar control unit.
>>
GO TO 5.
CHECKING SONAR CONTROL UNIT TYPE ID
1. Use Global Web-FAST (NISSAN parts catalogue) to search for the sonar control unit of the applicable Nissan Sentra vehicle and find the Type ID. Refer to “FAST linked” in the “CONSULT Operation Manual”.
  Note:
  For FAST linked parts, even if a system number cannot be acquired from the sonar control unit before replacement, the applicable ECU setting operation can still be performed by acquiring the system number from Global Web-FAST (NISSAN parts catalogue).
>>
GO TO 4.
WRITING Nissan Sentra Vehicle SPECIFICATION (FAST LINKED)
1. CONSULT
  
  Perform ECU setting according to the “C/U setting” procedure in the “CONSULT Operation Manual”. Refer to CONSULT Operation Manual.
>>
GO TO 5.
CHECK ALL ECU SELF DIAGNOSTIC RESULT
1. CONSULT
  1. Erase all ECU self-diagnosis results.
  2. Ignition switch OFF.
  3. Ignition switch ON.
  4. Check that all ECU self-diagnosis results have no DTC.
>>
Work End.

Configuration (sonar Control Unit)

...

Sonar System :: Dtc/circuit Diagnosis

...

Other materials:

U0300-00 Can Communication Data
Dtc Description DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection conditi ...

Component Function Check
Component Function Check CHECK FUNCTION CONSULT Select "Back door/trunk opener switch" in "Data Monitor" mode of "BCM(TRUNK)". Check that the function operates normal ...

Wheel Bearing
Wheel Bearing Item Standard Axial end play 0.05 mm (0.002 in) or less ...