Warning light | Name |
![]() |
Anti-lock Braking System (ABS) warning light |
![]() |
Brake warning light |
![]() |
Charge warning light |
![]() |
Door open warning light |
![]() |
Engine oil pressure warning light |
![]() |
Low fuel warning light |
![]() |
Low tire pressure warning light |
![]() |
Low windshieldwasher fluid warning light |
![]() |
NISSAN Intelligent Key® lock warning light (M/T models) (if so equipped) |
![]() |
NISSAN Intelligent Key® warning light (if so equipped) |
![]() |
P position selecting warning light (CVT models) (if so equipped) |
![]() |
Power steering warning light |
![]() |
Seat belt warning light |
![]() |
Supplemental air bag warning light |
Indicator light | Name |
![]() |
Continuously Variable Transmission (CVT) position indicator light (CVT models) |
![]() |
Cruise main switch indicator light (if so equipped) |
![]() |
ECO mode indicator light |
![]() |
Engine start operation indicator light (if so equipped) |
![]() |
Front fog light indicator light (if so equipped) |
![]() |
Front passenger air bag status light |
![]() |
High beam indicator light (blue) |
![]() |
Malfunction Indicator Light (MIL) |
![]() |
Overdrive off indicator light (CVT models) |
![]() |
Security indicator light |
![]() |
Side light and headlight indicator light (green) |
![]() |
Slip indicator light |
![]() |
SPORT mode indicator light |
![]() |
Turn signal/hazard indicator lights |
![]() |
Vehicle Dynamic Control (VDC) off indicator light |
Removal and installation
Audio unit
Exploded view
Audio unit
Audio unit bracket (LH)
Audio unit bracket (RH)
Removal and installation
Removal
Disconnect the negative battery terminal. Refer to pg-50, "removal and
installation (battery)".
Remove cluster lid c lower. Refer to ip-20, "re ...
Daytime light system inoperative
Description
The daytime light system is inoperative even though the combination switch
(lighting and turn signal switch)
and parking brake switch are in the normal setting, also whenever engine is
operating.
Diagnosis procedure
1.Check daytime light operation
Perform bcm(headlamp) daytim ...
P050A, P050B, P050E Cold start control
Description
ECM controls ignition timing and engine idle speed when engine is started
with pre-warming up condition.
This control promotes the activation of three way catalyst by heating the
catalyst and reduces emissions.
DTC Logic
DTC DETECTION LOGIC
NOTE:
If DTC P050A, P050B or P050E ...