Nissan Sentra manuals

Nissan Sentra Service Manual: Vehicle Recovery (Freeing a Stuck Vehicle)

Nissan Sentra Service Manual / General information / Precaution / Vehicle Recovery (Freeing a Stuck Vehicle)

Front

  1. Remove the hook cover from the bumper using a remover tool.
  2. Securely install the vehicle recovery hook stored with jacking tools.

Check that the hook is properly secured in the stored place after use.


Check that the hook is properly secured in the stored place after use.

WARNING:

CAUTION:

Rear

The vehicle rear recovery hook is located in the right rear undercarriage


The vehicle rear recovery hook is located in the right rear undercarriage area.

CVT

To tow a vehicle equipped with a CVT, an appropriate vehicle dolly MUST be placed under the towed vehicle's drive wheels. Always follow the dolly manufacture's recommendations when using their product.

If the vehicle is stuck in sand, snow, mud, etc., use the following procedure:

  1. Turn off the Vehicle Dynamic Control System.
  2. Make sure the area in front and behind the vehicle is clear of obstructions.
  3. Turn the steering wheel right and left to clear an area around the front tires.
  4. Slowly rock the vehicle forward and backward.

    Shift back and forth between R (reverse) and D (drive).

    Apply the accelerator as little as possible to maintain the rocking motion.

    Release the accelerator pedal before shifting between R and D.

    Do not spin the tires above 55 km/h (34 MPH).

  5. If the vehicle can not be freed after a few tries, contact a professional towing service to remove the vehicle.
Tow Truck Towing
NISSAN recommends that vehicle be towed with driving (front) wheels off the ground or that a dolly be used. CVT: Continuously Variable Transmission M/T: Manual transmission CAUTION: ...

Basic inspection
...

Other materials:

Wheel sensor
Front wheel sensor FRONT WHEEL SENSOR : Exploded View Front wheel sensor Front wheel sensor harness connector Front FRONT WHEEL SENSOR : Removal and Installation CAUTION: Be careful not to damage wheel sensor edge and sensor rotor teeth. When removing the front ...

Headlamp (hi) circuit
Description The IPDM E/R (intelligent power distribution module engine room) controls the headlamp high relay based on inputs from the BCM over the CAN communication lines. When the headlamp high relay is energized, power flows through fuses 41 and 42, located in the IPDM E/R. Power then flo ...

Brake pedal
Inspection BRAKE PEDAL HEIGHT Check the brake pedal height (H1) between the dash lower panel (1) and the brake pedal upper surface. Brake pedal height (H1) : Refer to BR-54, "Brake Pedal". CAUTION: Check the brake pedal height with the floor trim removed. STOP LAMP SWITCH AND BR ...

В© 2014-2026 Copyright www.nisentra.com