Description
Initial diagnosis of combination meter.
Dtc logic
Dtc detection logic
Dtc | Display contents of consult | Detection condition | Possible malfunction |
U1010 | CONTROL UNIT (CAN) [U1010] | When detecting error during the initial diagnosis of the can controller of combination meter. | Combination meter |
Diagnosis procedure
1.Replace combination meter
When dtc u1010 is detected, replace combination meter. Refer to mwi-77, "removal and installation".
>> Inspection end.
Dtc/circuit diagnosis
Malfunction area chart
Main line
Branch line
Short circuit
Main line between ipdm-e and dlc circuit
Diagnosis procedure
1.Check connector
Turn the ignition switch off.
Disconnect the battery cable from the negative terminal.
Check the following terminals and connectors fo ...
NISSAN vehicle immobilizer system
The NISSAN Vehicle Immobilizer system will not
allow the engine to start without the use of the
registered key.
If the engine fails to start using a registered key
(for example, when interference is caused by
another registered key, an automated toll road
device or automatic payment device o ...
Front coil spring and strut
Exploded View
Piston rod lock nut
Strut mount insulator
Strut mount bearing
Bound bumper
Coil spring
Lower rubber seat
Strut
Steering knuckle
Front
Removal and Installation
REMOVAL
Remove the wheel and tire using power tool. Refer to WT-47, "Exploded
View&quo ...