Dtc logic
Dtc detection logic
Dtc | Consult | Detection condition | Possible malfunction location |
U1000 | Can comm circ [u1000] | When combination meter is not receiving can communication signals for 2 seconds or more. | Combination meter |
Diagnosis procedure
1.Check can communication
Select self-diag results mode for meter/m&a with consult.
>> Go to lan system. Refer to lan-16, "trouble diagnosis flow chart".
Sensor power supply 2 circuit
Description
ECM supplies a voltage of 5.0 V to some of the sensors systematically divided
into 2 groups, respectively.
Accordingly, when a short circuit develops in a sensor power source, a
malfunction may occur simultaneously
in the sensors belonging to the same group as the shorted-circui ...
Rear door glass
Removal and Installation
REMOVAL
NOTE:
LH rear door panel shown; RH similar.
Remove the rear door finisher. Refer to INT-19, "Removal and
Installation".
Remove the vapor barrier.
CAUTION:
Use care to not damage or tear vapor barrier during removal.
Remove the rear door ...
C1115 ABS Sensor [abnormal signal]
DTC Logic
DTC DETECTION LOGIC
DTC
Display Item
Malfunction detected condition
Possible causes
C1115
ABS SENSOR
[ABNORMAL SIGNAL]
When difference in wheel speed between any wheel
and others is detected while the vehicle is driven, because
of installation of t ...