Nissan Sentra B18 (2020-2025) Service Manual: Trunk Room Trim
Exploded View
Exploded View
|
1. |
Trunk side finisher (LH) |
2. |
Trunk rear plate |
3. |
Reflector box assembly |
|
4. |
Trunk side finisher (RH) |
5. |
Box assembly |
6. |
Trunk floor trim |
|
7. |
Lower seatback finisher |
|
Clip |
|
Pawl |
|
|
Front |
Trunk Rear Plate
Removal and Installation
Removal and Installation
REMOVAL
Remove trunk floor trim. Refer to Exploded View.
Remove
clips (A).
Using a suitable tool, release clips and remove trunk rear plate. Refer to Exploded View.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
When installing, check that clips and pawls are accurately aligned with the holes on body panel, then press in.
Trunk Side Finisher
Removal and Installation
Removal and Installation
REMOVAL
Remove trunk rear plate. Refer to Removal and Installation.
Remove rear seat bolster. Refer to Removal and Installation — Rear Seat Bolster.
Position rear seatback forward.
Using a suitable tool, release clips and remove rear seatback finisher. Refer to Exploded View.
Using a suitable tool, release clips and remove trunk side finisher. Refer to Exploded View.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
-
Insert rear end of trunk side finisher into trunk weather strip.
-
When installing, check that clips are accurately aligned with the holes on body panel, then press in.
Other materials:
C106e-54 Steering Angle Sensor
Dtc Description
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen item
(Trouble diagnosis
content)
DTC detection condition
...
Oil Pan (lower)
Exploded View
Exploded View
1.
Rear oil seal
2.
O-ring
3.
Oil pan (u ...
Rear Seat Belt Buckle Switch. Removal and Installation
Removal and Installation
Removal and Installation
Warning:
Before servicing the SRS, place the ignition
switch in the OFF position, disconnect both battery terminals then
wait at least three minutes.
Do not use air tools or electric ...