Description
The key warning chime does not sound, when all of the following conditions are fulfilled.
Diagnosis procedure
1.Check bcm input signal
Is the inspection result normal? Yes >> replace the bcm. Refer to bcs-73, "removal and installation" (with intelligent key system) or bcs-126, "removal and installation" (without intelligent key system).
No >> go to 2.
2.Check key switch signal circuit
Check the key switch signal circuit. Refer to dlk-262, "diagnosis procedure".
Is the inspection result normal? Yes >> replace the bcm. Refer to bcs-73, "removal and installation" (with intelligent key system) or bcs-126, "removal and installation" (without intelligent key system).
No >> check applicable parts, and repair or replace corresponding parts.
The light reminder warning does
not soundSystem
STARTING SYSTEM (WITH INTELLIGENT KEY)
Component Parts Location
Starter motor
Transmission range switch (CVT Models)
IPDM E/R (view with air inlet duct
removed)
Clutch interlock switch (M/T Models)
ECM
Component Description
Component part
Description
Starter ...
Can communication circuit
Diagnosis procedure
1.Connector inspection
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Disconnect all the unit connectors on can communication system.
Check terminals and connectors for damage, bend and loose connection.
Is the inspection resu ...
B0093 FRont door satellite sensor LH
Description
DTC B0093 FRONT DOOR SATELLITE SENSOR LH
The front door satellite sensor LH is wired to the air bag diagnosis sensor
unit. The air bag diagnosis sensor
unit will monitor the front door satellite sensor LH for internal failures and
its circuits for communication errors.
PART LOCA ...