Nissan Sentra B18 (2020-2025) Service Manual: System Setting
Target Evaporator Temp Upper Limit
DESCRIPTION
Set the target evaporator temperature upper limit.
HOW TO SET
CONSULT
Select “TARGET EVAPORATOR TEMP UPPER LIMIT SETTING” in “Work support” mode of “HVAC”.
|
Work support items |
Display |
|---|---|
|
TARGET EVAPORATOR TEMP UPPER LIMIT SETTING |
Initial Setting |
|
Low |
|
|
Middle |
|
|
High |
Foot Position Setting Trimmer
DESCRIPTION
In FOOT mode, the air blowing to DEF can change ON/OFF.
HOW TO SET
CONSULT
Select “BLOW SET” in “Work support” mode of “HVAC”.
|
Work support items |
Display |
Defroster door position |
|
|---|---|---|---|
|
Auto control |
Manual control |
||
|
BLOW SET |
Mode1 (initial status) |
OPEN |
CLOSE |
|
Mode2 |
OPEN |
OPEN |
|
|
Mode3 |
CLOSE |
OPEN |
|
|
Mode4 |
CLOSE |
CLOSE |
|
When the battery cable is disconnected from the negative terminal or when the battery voltage becomes 10V or less, the setting of the discharge air mix ratio in FOOT mode may be cancelled.
Operation Inspection
Work Procedure
Work Procedure
DESCRIPTION
The purpose of the operational check is to check
that the individual system operates normally.
...
Other materials:
Removal and Installation
Removal and Installation
COWL TOP
REMOVAL
Remove
front wiper arm (LH/RH). Refer to Removal and Installation.
Remove cowl
top side trim cover (LH/RH). Refer to Exploded View.
Remove cowl
top clips. Refer to Exploded View.
Pull up on
cowl top to release from windsh ...
Dtc Diagnosis Procedure
DTC Diagnosis
Procedure
Note:
The Signal Tech II Tool [– (NI-50190)] can be used
to perform the following functions: Refer to the Signal Tech II User
Guide for additional information.
Activate and display TPMS sensor IDs
Display tire pressure reported ...
P0270 Fuel Injector (cylinder 4)
Dtc Description
DTC Description
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis
content)
DTC detection
condition
...
