Nissan Sentra Service Manual: Symptom diagnosis
The eco mode indicator lamp does not turn on
Description
The ECO mode indicator lamp does not turn ON when the ECO mode switch is operated.
Diagnosis Procedure
1.Perform combination meter on board diagnosis
Perform combination meter on board diagnosis. Refer to MWI-16, "Description".
Is the check result normal? YES >> GO TO 2.
NO >> Replace combination meter. Refer to MWI-77, "Removal and Installation".
2.Check dtc (tcm)
With consultv
- Start the engine.
- Check “self diagnostic results” in “transmission”.
Is any DTC detected? YES >> Check DTC detected item. Refer to TM-126, "DTC Index".
NO >> GO TO 3.
3.Check dtc (ecm)
With consult
Check “self diagnostic results” in “engine”.
Is any dtc detected? Yes >> check dtc detected item. Refer to ec-94, "dtc index".
No >> go to 4.
4.Check dtc (combination meter)
With consult
Check “self diagnostic results” in “meter/m&a”.
Is any dtc detected? Yes >> check dtc detected item. Refer to mwi-26, "dtc index".
No >> go to 5.
5.Check combination meter input/output signal
With consult
- Select “data monitor” in “meter/m&a”.
- Select “eco mode ind”.
- Check that “ECO MODE IND” turns ON/OFF when ECO mode switch is operated. Refer to MWI-20, "Reference Value".
Is any DTC detected? YES >> Replace combination meter. Refer to MWI-77, "Removal and Installation".
NO >> GO TO 6.
6.Check eco mode switch circuit
Check eco mode switch circuit. Refer to dms-34, "diagnosis procedure".
Is any dtc detected? Yes >> inspection end
No >> repair or replace malfunctioning parts.
Dtc/circuit diagnosis
Eco mode switch
Component function check
1. Check eco mode switch operation
Turn ignition switch ON.
Check ECO mode indicator lamp turns ON/OFF on combination meter when
turn ECO mode swit ...
Removal and installation
Eco mode switch
Removal and installation
Removal
Remove instrument lower panel LH. Refer to IP-21, "Removal and
Installation".
Remove ECO mode switch.
Installation
Installatio ...
Other materials:
Heating and cooling unit assembly
Exploded view
With air conditioning
Defroster seal
Center ventilator seal
Upper distribution module
Side ventilator seal (LH)
Blower motor
Blower unit
Intake door motor
Power transistor
Power transistor wiring harness
Front floor duct (lh)
Vent and defroster linkage
Mo ...
Doors
When the doors are locked using one of the
following methods, the doors cannot be opened
using the inside or outside door handles. The
doors must be unlocked to open the doors.
WARNING
Always have the doors locked while
driving. Along with the use of seat belts,
this provides ...
Rear-facing child restraint installation using the seat belts
WARNINGThe three-point seat belt with Automatic
Locking Retractor (ALR) must be used
when installing a child restraint. Failure to
use the ALR mode will result in the child
restraint not being properly secured. The
restraint could tip over or be loose and
cause injury to ...
