Nissan Sentra B18 (2020-2025) Service Manual: Roof Side Molding
Exploded View
Exploded View
|
1. |
Roof side molding |
2. |
Metal clip |
Removal and Installation
Removal and Installation
REMOVAL
Using
suitable tool (A), with protective tape (B), release roof side
molding from rear metal clip. 
: Metal clip
:
Front
Pull up
roof side molding from rear end to front end.
:
Front
CAUTION:
Use care when pulling the roof side molding to avoid damaging.
Using
suitable tool, release roof side molding from front metal clip and
remove roof side molding. 
: Metal clip
REMOVAL OF ROOF SIDE MOLDING CLIPS
Heat adhesive tape using a heat gun and peel roof side molding clips (body side) using a suitable tool.
CAUTION:
Be careful not to damage the body.
INSTALLATION
Clean tape removed surface with isopropyl alcohol or equivalent.
Use two-part epoxy adhesive.
|
Adhesive |
: 3M-weld DP–100 or equivalent |
Apply adhesive evenly to clip tape surface.
|
Thickness |
: Approximately 0.5 mm (0.020 in) |
Position clips in the proper location and press-fit until adhesive protrudes.
|
Press-fit limit |
: 19.6 N× 2 seconds |
Secure clips with tape per the following specifications:
|
5 to 10°C (41 to 50°F) |
: 1 hour or more |
|
11 to 23°C (52 to 73°F) |
: 30 minutes or more |
|
24°C or more (75°F or more) |
: 15 minutes or more |
CAUTION:
-
Use double-sided tape after hardening for roof side molding clips.
-
Securely insert molding rear end cap onto roof rear end cutout (installation standard).
-
When installing roof side molding of windshield glass portion, check that body side molding fastener is securely inserted and then press in.
-
Do not wash or expose Nissan Sentra vehicle to a wet environment within 24 hours of installation.
Other materials:
B1041-82 Vehicle Speed Signal
Dtc Description
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen items
(Trouble diagnosis
content)
DTC Detection Condition
...
Torque Converter Clutch Solenoid Circuit
Diagnosis Procedure
Diagnosis Procedure
CHECK HARNESS CONNECTOR
Ignition switch OFF.
Check the mating condition of TCM
harness connector and CVT unit harness
connector.
Is the inspect ...
Engine cooling system
The engine cooling system of the Nissan Sentra is factory-filled with a pre-diluted
mixture consisting of 50% Genuine NISSAN Long Life Antifreeze/Coolant (blue) and
50% water. This formulation is designed to provide reliable, year-round antifreeze
protection and effective engine cooling perfor ...