Nissan Sentra B18 (2020-2025) Service Manual: Removal and Installation - Rear Seat Bolster

Removal and Installation - Rear Seat Bolster

REMOVAL

Warning:

Do not leave any objects (screwdrivers, tools, etc.) on the rear seat bolster during seat repair. It can lead to personal injury if the side air bag module should accidentally deploy.

CAUTION:

• When removing or installing the rear seat bolster, handle it carefully to keep dirt out and to avoid damage.

• Do not drop, tilt, or bump the side air bag module while installing the rear seat bolster. Always handle it with care.

• After rear side air bag module inflates, the rear seat bolster must be replaced.

• When removing and installing the rear seat bolster, use shop cloths to protect components from damage.

• Before removing the rear seat bolster, turn the ignition switch OFF, disconnect both battery cables and wait at least three minutes.

Remove the seat cushion assembly. Removal and Installation.

Remove the bolt at bottom of rear seat bolster.

Disconnect the battery or batteries and wait at least three minutes. Refer to Battery Disconnect.

Disconnect harness connector from the rear side air bag module. Note:

Take note of harness routing and attachment locations for correct installation.

Remove the rear seat bolster.

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:

Make sure that the seat harness is not damaged during installation.

• Tighten the pivot bolt to specification.

  Exploded View.

© 2014-2026 Copyright www.nisentra.com