Nissan Sentra B18 (2020-2025) Service Manual: Removal and Installation
Warning:
-
Before servicing the SRS, place the ignition switch in the OFF position, disconnect both battery terminals then wait at least three minutes.
-
Do not use air tools or electric tools for servicing the rear seat bolster.
The rear side air bag module is part of the rear seat bolster. For removal and installation of the rear seat bolster, refer to Removal and Installation.
CAUTION:
-
Always work from the side or back of the rear seat bolster, do not work in front of rear seat bolster.
-
Do not insert any objects into the rear side air bag module.
-
Do not attempt to disassemble the rear side air bag module.
-
Do not expose the rear side air bag module to temperatures exceeding 93°C (200°F).
-
Do not expose the rear side air bag module to any oil, grease, detergent or water.
If the Nissan Sentra vehicle has been involved in a collision and the rear side air bag module has been deployed, the rear seat bolster must be replaced.
Other materials:
Preparation
Special service tool
The actual shape of the tools may differ from those illustrated here.
HFC-134a (r-134a) service tool and equipmen.T.
Do not mix HFC-134a (R-134a) refrigerant and/or its specified oil with CFC-12
(R-12) refrigerant and/or its oil.
Separate and non-interchangeable se ...
P159f Active Grille Shutter
Dtc Description
DTC Description
DTC DETECTION LOGIC
Active grille shutter normally stops within zone which
is defined by zone (90°±20°).
If the active grille shutter stops within zone stuck
error is detected, and if the active grille shutter stops at position beyond
zon ...
Failsafe
FailSafe
Display contents of
CONSULT
Fail-safe
Cancellation
B2001-45: Intelligent Key
unit
...
