Nissan Sentra B18 (2020-2025) Service Manual: Removal and Installation
REMOVAL
Remove rear suspension member. Refer to Removal and Installation.
Remove the lower connecting rod nuts.
Disconnect the connecting rods from the rear suspension links.
Remove the
stabilizer bar clamp bolts (A) using power tool.
Remove the stabilizer bar clamps.
Remove the stabilizer bar.
Remove the connecting rod nuts from stabilizer bar and remove connecting rods.
INSTALLATION
Installation is in the reverse order of removal.
-
Tighten the connecting rod nut to the specified torque while holding the hexagonal part of the connecting rod stud.
Exploded View
Exploded View
1.
Stabilizer bar
2.
...
Other materials:
Antenna Amp
Removal and Installation
Removal and Installation
Removal
Remove rear
pillar finisher (RH). Refer to Removal and Installation — Rear Pillar
Upper Finisher.
Remove
screw (A) from antenna amp (1).
Disconnect
the harness connector and remove the antenna amp.
Install ...
Eps branch line circuit
Diagnosis Procedure
1.Check connector
Turn the ignition switch off.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the eps control unit for damage,
bend and loose connection (unit
side and connector side).
Is the inspection result norm ...
Instrument lower panel lH
Removal and Installation
REMOVAL
Remove the instrument side finisher LH (1) using a suitable tool.
Remove the hood and fuel filler handle assembly from the instrument
lower panel LH. Refer to DLK-191,
"FUEL FILLER OPENER CABLE : Removal and Installation".
Release the ...
