Nissan Sentra B18 (2020-2025) Service Manual: Removal and Installation
Removal
Remove rear suspension member. Refer to Removal and Installation.
Remove the suspension arm from the knuckle using power tool.
Remove the suspension arm from rear suspension member using power tool.
Installation
Installation is in the reverse order of removal.
-
Perform the final tightening of the suspension arm bolts and nuts at the knuckle, under unladen conditions with tires on level ground.
CAUTION:
Do not reuse the suspension arm nuts.
-
Check rear wheel alignment. Refer to Wheel Alignment (Unladen*1).
-
Adjust the neutral position on steering angle sensor. Refer to Description.
Exploded View
Exploded View
With Drum Brake
1.
Rear suspension member
...
Front Lower Link
...
Other materials:
Confirmation Procedure
Confirmation Procedure
PRECONDITIONING
If “Confirmation Procedure” has been
previously conducted, always place the ignition switch OFF and wait
at least 10 seconds before conducting the next test.
>&g ...
Rear View Camera
Removal and Installation
Removal and Installation
Removal
Remove
trunk lid finisher. Refer to Removal and Installation.
Remove
trunk lid damper bolts (A) and trunk lid damper (1).
Disconnect
the rear view camera harness connector.
Using a
suitable tool, release pa ...
Refrigerant Pressure Sensor
Component Function Check
Component Function Check
CHECK REFRIGERANT PRESSURE SENSOR
FUNCTION
Start engine and warm it up to normal
operating temperature.
Turn A/C switch and blower fan switch
ON.
...
