Nissan Sentra B18 (2020-2025) Service Manual: Removal and Installation
REMOVAL
Disconnect the battery negative terminal. Refer to Battery Disconnect.
Remove front undercover. Refer to Removal and Installation.
Remove starter motor bolts.
For CVT models, Remove heater thermostat bolt and reposition heater thermostat. Refer to Exploded View.
Support and reposition starter motor.
Remove terminal "S" nut and harness.
Remove terminal "B" nut and harness.
Remove starter motor.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
Be careful to tighten terminal "B" nut to the specified torque. Refer to Exploded View.
Exploded View
Exploded View
1.
Cylinder block
2.
...
Inspection
Inspection
INSPECTION
MAGNETIC SWITCH
Remove
starter motor from vehicle. Refer to Removal and Installation.
Connect 12V
battery to starter motor as shown. Check that pinion gear (1) ...
Other materials:
B132a External Usb
Dtc Description
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis
content)
DTC detection condition
...
Evaporative emission system
EVAPORATIVE EMISSION SYSTEM : System Description
SYSTEM DIAGRAM
INPUT/OUTPUT SIGNAL CHART
Sensor
Input signal to ECM
ECM function
Actuator
Crankshaft position sensor (POS)
Engine speed*
EVAP canister
purge flow control
EVAP canister purge volume
control ...
Cowl top
Exploded view
Cowl top seal
Cowl top grille cap
Cowl top cover
Cowl top extension
Cowl top extension insulator
Clip
EPT seal [t: 3.0 mm (0.12 in)
Cowl top cover cap
EPT seal [t: 5.0 mm (0.20 in)]
Pawl
Clip
Front
Removal and installation
COWL TOP COVER
Removal
Rem ...
