Nissan Sentra manuals

Nissan Sentra Service Manual: Removal and installation

Eco mode switch

Removal and Installation

Removal

  1. Remove instrument lower panel LH. Refer to IP-21, "Removal and Installation".
  2. Remove eco mode switch.

Installation

Installation is in the reverse order of removal.

Dtc/circuit diagnosis
Eco mode switch Component function check 1. Check eco mode switch operation Turn ignition switch on. Check ECO mode indicator lamp turns ON/OFF on combination meter when turn ECO mode switc ...

Eco mode (cvt)
...

Other materials:

Vehicle load capacity
Do not exceed the load limit of your vehicle shown as “The combined weight of occupants and cargo” on the Tire and Loading Information label. Do not exceed the number of occupants shown as “Seating Capacity” on the Tire and Loading Information label. To get “the combined weight of ...

P0452 EVAP Control system pressure sensor
DTC Logic DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition Possible cause P0452 EVAP SYS PRES SEN (Evaporative emission system pressure sensor/switch low) An excessively low voltage from the sensor is se ...

Making a call
To make a call from a phone connected to the vehicle’s Bluetooth® Hands-Free Phone System: NOTE: Available commands different if system is in Manual Control mode. See “Manual Control” in this section for more information. Press the button. The system will prompt you for a command. ...

© 2014-2026 Copyright www.nisentra.com