Nissan Sentra Service Manual: Removal and installation
Nats antenna amp
Removal and installation
Removal
- Remove instrument finisher b. Refer to ip-14, "exploded view".
- Using a suitable tool release the pawls on either side and remove the NATS antenna amp. from the pushbutton ignition switch.
Installation
Installation is in the reverse order of removal.
Push-button ignition switch
Removal and installation
Removal
- Remove the NATS antenna amp. Refer to SEC-135, "Removal and Installation".
- Using a suitable tool release the pawls and remove the push-button ignition switch from instrument finisher b.
Installation
Installation is in the reverse order of removal.
Symptom diagnosis
Engine does not start when intelligent key is inside of vehicle
Description
Engine does not start when push-button ignition switch is pressed while
carrying intelligent key.
Note:
Check that ...
Other materials:
System description
Component parts
Component parts location
Ipdm e/r (contains ignition relay-1)
Bcm (view with instrument panel removed)
Fuse block (j/b) (front)
Fuse block (j/b) (back)
Blower relay
Ignition relay-2
Accessory relay-1
Push-button ignition switch
Component description
...
Satellite radio reception (if so equipped)
When the satellite radio is used for the first time
or the battery has been replaced, the satellite
radio may not work properly. This is not a malfunction.
Wait more than 10 minutes with satellite
radio ON and the vehicle outside of any metal or
large building for satellite radio to receive a ...
Washer fluid level switch circuit
Description
Transmits the washer level switch signal to the combination meter.
Diagnosis procedure
Regarding Wiring Diagram information, refer to MWI-28, "Wiring Diagram".
1.Check washer level switch signal circuit
Turn ignition switch off.
Disconnect combination meter connecto ...
